hi! i commissionning a drive 6RA8031with the BOP when i send the power on via terminal 12

the run state r0002 show me 12 meanning

i check the p0852 and all is set to 1 but same thing and the drive not start

how to solve it, also i try to connect on the CUD with starter via pc adapter usb but it not working

please help

------------------------------------------------------------------------------------------
Split from SINAMIC 6RA80 DC Binnector and Connector Parameter changes.

fagbe

hi! i commissionning a drive 6RA8031with the BOP when i send the power on via terminal 12

the run state r0002 show me 12 meanning

12: o1.2 Wait for operating enable (signal source acc. to p0852)

i check the p0852 and all is set to 1 but same thing and the drive not start

how to solve it, also i try to connect on the CUD with starter via pc adapter usb but it not working

please help

 

Hello,

Welcome to forum.

Please open new topic instead posting your query in old topic.

Please refer SINAMICS DCM, List Manual, Firmware version 1.5 (based on 5.1 SP1) manual function diagram no 2580, drive control word enable input is made ON by an AND gate, i.e. p0852 & r53010.4 must be ON. r53010.4 is made high when DI 2 i.e. X177:13 is ON. So please check & ensure that DI  2 - X177:13 is ON i.e. drive operation is enabled.

Hope this helps. 

thanks for your support

i finally connect to the CUD with STARTER and the drive work already

[snip]