first I d like  to try this library using PLSIM but i got error and 16#8006 status:"Cannot open software gate of technology module. Remedy: Check the parameterization of the technology module".

I checked all the parameters but i didn t resolve it, do you have any advises?

Thanks

aleb2, it looks like this library accesses hardware directly.  You may need to use PLCSim Advanced, if you have it.

I think you can not simulate the TM-Count 1x24V Module with PLCSim Advanced. You also can not simulate DIs of an ET200SP with PLCSIm Advanced.

Therefor you would need SIMIT in combination with PLCSimAdvanced.

Greetings

Hi

From the PlcSimAdvanced v4 manual:  "Technology module TM Count - Error message of instruction High_Speed_Counter" so i guess it is possible to simulate TM Count

Hi aleb2,

Sorry, my bad.  Brachiosaurus is right.  You will need to simulate the TM externally.  By itself, PLCSim Advanced won't make the TM behave like it's counting in real life, as required 2SpeedPositioning blocks.  You need a behavior model for this, such as provided by SIMIT.

The function you mentioned in the PLCSim Advanced manual is simulation of diagnostic faults generated by the TM.  This is different from the above.