Readout commissioned parameters using BOP

Is it possible to readout only parameters wich are different than default/factory using the BOP?

Drive:6SE6440-2UE33-7EA1

We have some difficulties with a drive wich powers the gantry of a loading crane. When the operator controls the machine from movement to a standstill, F0002 occurs an the brakes fall abrupt due to the drive fault.

This drive is recently replaced due to another issue. The drive is then commisioned with parameter settings of a sheet using the BOP. The sheet was not complete as I found out Paramaters for dynamic braking were missing. I checked the settings on the old drive and found out that parameter P1237  and P1254 were not commissioned wich makes sense why we now encounter this issue.

I would like to readout all the changed paramters using the BOP to check if there are more parameter differences between the old and the new drive. I checked the parameter list and espacially P003 and P0013 but cannot make out if this option is available.

This function is someting I used before on older Siemens DC-MASTERS wich is very helpful in these situations.

Hello;

Ayman's answer is quite correct.

If you want a slightly more detailed explanation, look at this discussion:

https://support.industry.siemens.com/forum/ca/en/posts/aop-and-bop/68700

Hope this helps,

Daniel Chartier