Hi, guys

I have SINAMICS S210

It has some problem

So I have to commision S210 again

As you know There is first time login page

But  I can not access the page 

Because I forget the password for Administrator

Shoud I do factory reset?

and Let me know how to factory reset with X127 port

Best regards,

Lee

Hi PLCO7

If you have forgotten the password for the administrator account on your SINAMICS S210, and you are unable to access the first-time login page, then a factory reset may be necessary. Here's how you can perform a factory reset of the S210 drive using the X127 port:

1. Power off the S210 drive.

2. Connect a PC or laptop to the X127 port on the drive using a suitable cable (such as a USB to RS485 adapter).

3. Use a terminal program (such as PuTTY) to open a serial connection to the drive by entering the correct COM port and baud rate settings.

4. Power on the S210 drive.

5. Wait until the "Running" LED on the drive starts to flash (indicating that the drive is in setup mode).

6. At this point, press the Enter key on the terminal program to access the drive's setup menu.

7. Scroll down to the "Factory Reset" option using the arrow keys and press Enter.

8. Follow the prompts to confirm the factory reset.

9. Once the reset is complete, power cycle the S210 drive to exit setup mode.

After performing the factory reset, you will need to redo the commissioning process for the drive. Make sure to document any configurations or settings you make during the commissioning process so that you can refer to them later if needed.

Hello,

the best way to reset the SINAMICS is described at following link: 

https://support.industry.siemens.com/cs/ww/en/view/109755657