6/3/2009 7:09 AM | |
Posts: 217 Rating: (52) |
Hi, I think you should go through the S7 200 manual again. Because it content lot of information about shift registers also don’t forget to see the help file of micro win software it is very easy to use and had lot of information go to the relative block and just press F1. Because you were new to PLC (As you said). Some time these simple things solve big problems. I think you have a 200 CPU with you, so best way for you is try to do it your self and understand it your self. When you trying if you fiend problem then back to the forum with specific question where you get the problem. Best regards. |
Follow us on