In the attached diagram I'm using networkoutput NQ1 to display the state of an output (Q1) on the webpage. The output of NQ1 apperently needs to terminate to something, What can I use for this ?

Or should I use something else to display Q1's state on web ?

 thnx! 

I also found out I can simply use blocktype Q and select Q1 in the button settings on LWE. Much easier :-)

ixo65

You have assigned the address V2.1 to network output NQ1.
But you also have a problem with the network input NI1 (V1.1).
You have an overlap with both addresses.

In the Parameter VM Mapping, you used the words VW0, VW2, VW4, and VW6.
V1.1 is a bit in Word VW0, V2.1 is a bit in VW2.