Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

fault F60092

Created by: AutoGen_7888312 at: 10/9/2023 4:15 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

10/9/2023 4:15 AM	Rate (0)
AutoGen_7888312 Joined: 9/30/2023 Last visit: 9/30/2023 Posts: 1 Rating: (0)	Dear sir I am facing a problem on fault F60092 drive is trip, any explanation to over come this problem sir. ------------------------------------------------------------------------------------------ Split from Problem with Sinamics dcm: F60300 and F60092.
	Last edited by: Jen_Moderator at: 10/09/2023 04:18:00 New subject after splitting
Suggestion To thank Quote Answer

10/9/2023 6:40 PM	Rate (0)
Graeme Platinum Member Joined: 6/4/2008 Last visit: 11/10/2024 Posts: 1503 Rating: (325)	Hi, do you have any connected items/wires on the analog supply pins. If so, disconnect and see if the problem persists. Have you got a potentiometer in circuit, and if so, what value? Have you connected it as per recommendations in the control module manual in the block diagram. If not, I would be reviewing your wiring, i.e. common ground, or even floating voltages causing problems on your -10V supply. Regards, Graeme

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on