I use winCC V8 and win11pro.

When I add the raw data type inside the simatic s7 1500 connection and connect it to the corresponding db inside the PLC, the address of the raw data tag is fine. However, when I load the AS symbols from the PLC, the address of the Raw data tag turns red and I get the message: "The AS symbol assigned to the tag was not found".

I can manipulate AS symbols properly.

If I create a new connection (same channel and oms+), leave only raw data tags in the first one, and put AS symbols in the second one, it still does not recognize the address of the raw data tags.

Is there a solution how to combine these two?