Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Pasting S7 V5.4 Block to S7 Basic 10

Created by: BaldEagle56 at: 9/15/2010 10:01 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

9/15/2010 10:01 PM	Rate (0)
BaldEagle56 Posts: 14 Rating: (1)	I have a protected FC block created with S7 V5.4 SP3 that I would like to use (without rewriting) in an S7-1214C project. I can copy the block in S7 V5.4, but the paste option is not available (greyed out) in S7 Basic 10.5 SP2. Is there a way to get around this?
BaldEagle56 Posts: 14 Rating: (1)
Suggestion To thank Quote Answer

9/15/2010 10:06 PM	Rate (0)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 11/1/2024 Posts: 10229 Rating: (1181)	Hello, I am afraid you should write it again in "basic" software. Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

9/15/2010 10:11 PM	Rate (0)
BaldEagle56 Posts: 14 Rating: (1)	Thanks, Hristo. This confirms my fear. "I am not lazy - just efficient!"
BaldEagle56 Posts: 14 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on