Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Tool no in the screen is Erased by pressing Reset SK

Created by: ŠΜS at: 4/7/2011 6:39 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

4/7/2011 6:39 PM	Rate (0)
ŠΜS Silver Member Joined: 6/7/2010 Last visit: 7/9/2024 Posts: 571 Rating: (37)	Dear All, I am facing an problem in ATC, When i call T command, The program Starts & End.After reading M06 command the Tool number is displayed in the Screen. But when is press reset SK , the tool number is Erased in the screen.I think i need to change an parameter ( G code reset) I dont revember Exately. Could any one suggest.
	Regards, ŠΜS
Suggestion To thank Quote Answer

4/7/2011 7:11 PM	Rate (0)
Caldas Bronze Member Joined: 9/10/2007 Last visit: 11/13/2024 Posts: 71 Rating: (1)	See the MD20110 RESET_MODE_MASK bits0 and 6. It can be useful for you. Good luck.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on