Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

problem with CP 1616

Created by: sotima at: 12/18/2006 9:42 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

12/18/2006 9:42 AM	Rate (0)
sotima Posts: 8 Rating: (0)	hI, Ihad bought to Siemens the "SIMATIC NET: DK-ERTEC 400 PNIO"That it comprises: - "DK-ERTEC 400 PNIO V2.0" 6 "Tornado 2.2.1/VxWorks 5.5.1" sw - "SIMATIC NET: DK-16xx PN IO V 1.0" & V 2.0 sw - "Development kit for PROFINet IO V 2.0" sw - "SIMATIC NET: CP 1616 V1.0" & V 2.0 sw - Evaluation Board ERTEC 400 PNIO (as device IO) hw - CP 1616 (as controller IO) hw How must be installed CP 1616? it is inserted in slot-PCI of one pc with winXP SO. I have tried following the supplied instructions, but I do not succeed to activate the communication between device and controller thank you for your attention Sotima
sotima Posts: 8 Rating: (0)
Suggestion To thank

12/21/2006 8:57 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 11/18/2024 Posts: 4113 Rating: (195)	Closed: cause thread was posted twice. The other thread you can find here: CP 1616 - ERTEC 400 KIT.
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on