Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

EM 231

Created by: LUISMCC at: 6/5/2007 12:41 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

6/5/2007 12:41 AM	Rate (0)
LUISMCC Posts: 7 Rating: (0)	Hello. I want to connect an I modulate EM 231 for the mensuration of 4 temperatures. That configurations should make in the program to treat those data? Are IW0, 1, 2 and 3 designated automatically? That I have to keep in mind in system Block besides suppressing the filters? Thank you
LUISMCC Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

6/5/2007 3:47 AM	Rate (0)
KLooPY Posts: 38 Rating: (5)	Hi LUISMCC, Keep in mind that analog inputs are AIW0, AIW2, AIW4, etc If I don`t remember bad, you have a wizard that do the dirty job for you in the configuration. That is all I can help you, may be someone more experienced in RTD could be more helpful Regards from Argentina KLooPY
KLooPY Posts: 38 Rating: (5)
Suggestion To thank Quote Answer

7/20/2011 4:29 AM	Rate (0)
am_sober Posts: 9 Rating: (1)	Yes it will address automatically if im not mistaken. pls also refer the attachment for info if at all it helps.. ^^ Attachment IO addressing.pdf (305 Downloads)
am_sober Posts: 9 Rating: (1)
Suggestion To thank Quote Answer

7/20/2011 9:24 AM	Rate (0)
a1b2c3 Posts: 154 Rating: (17)	The easiest way to see the addresses from your EM231 is to look at PLC--> Information. There you can see all your extension modules with the start address.
a1b2c3 Posts: 154 Rating: (17)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on