Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

trend time problem

Created by: camdal19 at: 6/7/2011 10:14 PM (6 Replies)

Rating (0)

Thanks 0

7 Entries

6/7/2011 10:14 PM	Rate (0)
camdal19 Posts: 2 Rating: (0)	Hello, we have a single station project PCS7 V7.1 with Cemat V7.1, our problem is about trend showing time, PLc time,PC time are correct and time synchronization configuration is applied according to your documet and it is also ok, the problem is when I open C_measure block trend faceplate it is directly showing date and time two days after from system time, means 2 days future. when ı had cerated project the pc time was wrong and I did'nt see it I activated runtime after that I see time is not ok ,I corrected PC time the alarm time showing correctly but this trend time is not ok.When I close project and delete the files inside the Archieve manager folder and again activate runtime it shows correct time but after some time it show again wrong.can you help me.. thanks Attachment trend1.jpg (109 Downloads)
camdal19 Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

6/7/2011 10:26 PM	Rate (0)
ABN Posts: 212 Rating: (12)	hi, in online trend properties there is a property called "apply project settings". do it and check the same
ABN Posts: 212 Rating: (12)
Suggestion To thank Quote Answer

6/8/2011 4:24 AM	Rate (0)
Niranjan Prasad Posts: 691 Rating: (37)	Open the Lag logging and save it. then activate the WinCC project
Niranjan Prasad Posts: 691 Rating: (37)
Suggestion To thank Quote Answer

6/16/2011 11:49 AM	Rate (0)
Import-User-1 Posts: 3609 Rating: (29)	camdal19 thank you I already tested but still same, but the problem is like that when I deactiveted win CC runtime and activated again online trend time and normal pc time starts together bur after some while trend time is going faster and starts showing future time, so after some time the difference between two time is going bigger and bigger, is it possible relation with cycle time or what can I do for this,, thank you for your help..
Import-User-1 Posts: 3609 Rating: (29)
Suggestion To thank Quote Answer

6/17/2011 1:34 AM	Rate (0)
ABN Posts: 212 Rating: (12)	Please check time Syncronization. This issue accurs only if Time Sync is not done correct between Master and Slave system.
ABN Posts: 212 Rating: (12)
Suggestion To thank Quote Answer

8/22/2011 12:56 PM	Rate (0)
A.D.P. Posts: 1 Rating: (0)	Dear All, I am also facing the same problem mentioned by camdel19. please update me if anybody has a solution. Dear Camdel19 have u got the solution for the same. Regards, ADP
A.D.P. Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

8/23/2011 6:14 PM	Rate (0)
camdal19 Posts: 2 Rating: (0)	Hi, I solved problem but not changing any settings with the project, because when I open same project with another PC it is working properly, so I changed PC and run same project it is working fine..Before this I tried many things, format pc install PCS7 and Cemat again, or change all syncronization setting but none of these are usefull .. Regards
camdal19 Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on