Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Editing graphics in Win CC Flexible.

Created by: @JesperMP at: 10/17/2005 11:06 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/17/2005 11:06 AM	Rate (0)
@JesperMP Posts: 54 Rating: (5)	Hi all. I have imported a project from Protool. It contains graphic bitmaps, and graphic lists. In Protool I could easily edit a bitmap (Windows paint would be opened). In Win CC Flex I can open up the graphic list, but I cannot edit the graphics in the list. If I open the properties for a graphic entry, a menu box opens where I can select "Create new graphic from file." "Create new graphic from OLE object." "Delete graphic." There is no "Edit graphic". If I doubleclick on an existing graphic in the list, I get an error message "General. Error closing graphics editor". Also, I see no place where I can get the graphics out of the Win CC Flex project in order to edit them externally. Thanks.
@JesperMP Posts: 54 Rating: (5)
Suggestion To thank Quote Answer

10/19/2005 9:02 AM	Rate (0)
Nemo Posts: 3149 Rating: (171)	Hello JesperMP, I´ve tested it on my Wincc flexible project. By doubleclicking on a graphic in the graphic list, the editor for modifying an existing graphic opened. => please check whether you can open in a new (NOT migrated WinCC flexible -project) a graphic by double-clicking. => then your WinCC flex installation is ok (and your migrated project is causing the problem) If you are getting this behaviour in a new project as well, I would recommend a new installation of your system. Good luck, Nemo[8)]
Nemo Posts: 3149 Rating: (171)	Last edited by: Nemo at: 10/19/2005 9:03 AM Last edited by: Nemo at: 10/19/2005 9:03 AM
Suggestion To thank Quote Answer

11/4/2005 4:13 PM	Rate (0)
@JesperMP Posts: 54 Rating: (5)	I got it solved with help from Siemens support. They had to send me a reg-file to repair the registry.
@JesperMP Posts: 54 Rating: (5)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on