Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SHOPMILL

Created by: danial at: 6/23/2007 7:23 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

6/23/2007 7:23 PM	Rate (0)
danial Posts: 31 Rating: (0)	Hellow friends, I would like to install theSHOPMILL on PCU20 , with system 840D power line. I have: - CD:"Network manger sw6.X" with part number: "6FC5463-0FA03-0AA0" - CD:"SHOPMILL sw6.X" with part number: "6FC5463-6FA20-4AG0" How can I do that? THANKS SO MUCH.
danial Posts: 31 Rating: (0)
Suggestion To thank Quote Answer

6/24/2007 10:17 PM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Dear Sir Firstly, you must make sure that your versions of HMI, NCK and PLC software are compatible. You must install SM to a flash card. Also you will need to make major modifications to the PLC program and NCK MD. For further assistance, Please follow the link below. https://www.automation.siemens.com/doconweb/content.asp?item=10943&cd=sinumerik_simodrive_04_2007_e&scope=all Good luck, This is not a simple task. SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on