User Prompt - MMC Syntax

Hello,

here is an example of the MMC command. It shows the 3 different modes:
- Synchronous
- Asynchronous
- No Acknowledgment

Copy the .COM files to
F:\dh.dir\cus.dir or
F:\dh.dir\cma.dir

The example uses the GUDs defined in the MGUD.DEF for user input in the masks, you have to activate them.

The picture used in the example is from standard cycles i.e. it is included in F:\dh.dir\cst.dir\....
You can use your ownpictures of course. In this case you have to create the folders
1024.dir
800.dir
640.dir

in

F:\dh.dir\cus.dir\hlp.dir or
F:\dh.dir\cma.dir\hlp.dir

and put your pictures there for the various screen resolutions.

This example is based on the examples described in the documentation, see Chapter 3.3 at this link: https://www.automation.siemens.com/doconweb/pdf/SINUMERIK_SIMODRIVE_04_2010_E/IHA.pdf?p=468#page=468&view=FitBH,0&pagemode=none

If you want to use BTSS variables (for example R parameters) for mask parameters instead of GUDs, you can look at the bild_gr_btss.txt for an example.
Note: this does not fit the whole example, it is just to show the syntax for BTSS variables.