Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

What is the meaning of logic

Created by: PISCEAN 2010 at: 7/26/2013 7:09 AM (2 Replies)

Rating (1)

Thanks 2

3 Entries

7/26/2013 7:09 AM	Rate (0)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 11/14/2024 Posts: 8092 Rating: (878)	Hello Experts, On 840Di with ATC in FC32 i.e. ATC logic netwoek 55 is as follows. Network 55 CALL FC 15 IN0 : =M195.0 IN1 : =3 IN2 : =M25.6 IN3 : =FALSE IN4 : =FALSE IN5 : =2.000000e+002 IN6 : =2.000000e+003 OUT7 : =M190.2 OUT8 : =M190.3 OUT9 : =M190.4 OUT10 : =M190.5 I learnt as FC15 is protected as such I couldnot read it. My query is what is the meaning of this logic? What are these IN0...IN6; OUT7...OUT10? Can any help me to understand this as well as understanding/reading of other protected FCs? Thanks in advance. DEEP.

Suggestion To thank

7/26/2013 10:46 AM	Rate (1)
CNC600 Silver Member Joined: 10/27/2009 Last visit: 3/15/2024 Posts: 455 Rating: (77)	CALL FC 15 IN0 : = "Start" (start bit) IN1 : = "AxisNo" (MACHAX number) IN2 : = "IC" (FALSE=absolut movement, TRUE = incremental movement) IN3 : = "Inch" (FALSE = metric, TRUE = imperial) IN4 : = "HWeelOv" (FALSE = no Handwheel overlay, TRUE: Handwheel overlay possible) IN5 : = "Pos" (2.000000e+002 ==> 200, destination position) IN6 : = "FRate" (2.000000e+003 ==>2000, feedrate) OUT7 : = "InPos" (Output: movement finished completely) OUT8 : = "Active" (Output:movement ongoing) OUT9 : = "StartErr" (Output: no axis start possible) OUT10 : = "Error" (Output: error during movement) The FC15 was developed for axis movement by PLC. The parameters IN0..OUT10 occure because the FC15 was not inserted from Toolbox (e.g. Online upload from PLC-CPU) The FC15 will not supported anymore, the functionality is integrated in FC18 completely.
	hope that helps CNC600
Suggestion To thank
This contribution was helpful to 2 thankful Users PISCEAN 2010 rmb_cardoso

7/26/2013 11:34 AM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 8/20/2024 Posts: 2682 Rating: (135)	Thread closed, because question is already discussed in the following thread What/How to read below mentioned PLC logic? Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on