Guys,

I understand this is unrelated, but this is my first time here. could someone please answer my question or tell me where to posted? I am facing a commissioning deadline.

I am using CONT_C  in a function block. I call the FB in a Cyclic Program (OB32).  when the PID is in manual I can change the Block CV  by entering a manual value of 0-100%.  The problem is starts when I put the loop in Automatic.  It is a simple Flow control loop. As soon as I put the loop in Automatic, the loop becomes very unstable. Proportional gain is 0.1, Ti is 0 ms, PV_FAC=1.  Derivative is also 0.  SP=1100, PV (0-1800).

My Question:  Why is this loop become so unstable with such a very small gain?  Is this because my SP and PV can only be between (-100 to 100 %)?

Thank you very much for helping me.

------------------------------------------------------------------------------------------
Split from TIA Portal Updates.

The second thread with the subject Siemens, CONT_C, PID, TIA 15 is published within the conference SIMATIC Technology.

Best regards
Jen_Moderator