11/25/2019 8:05 AM | |
Joined: 12/20/2018 Last visit: 2/21/2024 Posts: 9 Rating:
|
Am I able to access this tool data with winscp? I looked for nc_act.dir/to.dir and cannot find anywhere. I would like to save the tool list at the end of each machining cycle in case of NCU failure. Thanks, Ben ------------------------------------------------------------------------------------------ |
Last edited by: Jen_Moderator at: 11/25/2019 13:39:13New subject after splitting |
|
11/25/2019 1:41 PM | |
Joined: 6/19/2017 Last visit: 8/5/2024 Posts: 8175 Rating:
|
Best regards Jen_Moderator |
My Forum is the place to personalize your profile, |
|
Follow us on