Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Problem with ProTool after installing WinCCflexible 2008 SP1

Created by: Black Mullie at: 6/2/2009 11:13 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

6/2/2009 11:13 AM	Rate (0)
Black Mullie Posts: 5 Rating: (0)	Hello, This problem occurred after installing WinCCflexible 2008 SP1. Befor installing WinCCflexible 2008 SP1 Protool was working well. I used ProTool v6.0 SP2 and was advised to install Protools v6.0 SP3. The problem remained. Who has the solution?
Black Mullie Posts: 5 Rating: (0)	Last edited by: CS Moderator at: 6/2/2009 11:58 PM new subject after splitting
Suggestion To thank Quote Answer

6/2/2009 12:27 PM	Rate (0)
UMENCHO Diamond Expert Joined: 3/21/2006 Last visit: 11/1/2024 Posts: 10229 Rating: (1181)	Hi This advise about SP3 is correct. Look at WinCC_flexible_2008_V1_3.pdf And try the same way with reinstall of Protool. (delete also manual in registry all regards Protool. You will suprise how many things is this "all"). Best regards Hristo Mihalev

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on