Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Micro Master 6SE3116 only - - - - in display

Created by: BuNNy-RaBBiT at: 8/18/2008 1:21 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

8/18/2008 1:21 PM	Rate (0)
BuNNy-RaBBiT Posts: 2 Rating: (0)	Hello, My micro master 6SE3116 is broken somehow.. It only shows Four - in the display, programming is posible but if i return to the main screen i see the four - again. Pressing Start, Stop, Jog, <> has no effect. Hope someone knows the fault. Greets, G.Vedder Holland
BuNNy-RaBBiT Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

8/20/2008 6:50 PM	Rate (0)
Tractor Gold Member Joined: 3/27/2008 Last visit: 11/3/2024 Posts: 1144 Rating: (142)	This may be a switch mode power supply failing to start up. The starter was a capacitor C65 on the lower board. From memory this was an electrolytic. To get at this lift off the upper control board, C65 is below on the power board. I cannot guarantee this is the problem as this drive is quite old now, and I guess it has had a good life.
	Tractor
Suggestion To thank Quote Answer

8/21/2008 12:25 AM	Rate (0)
BuNNy-RaBBiT Posts: 2 Rating: (0)	Hey tractor! Thnx for you`re reply! I will try that.. Greetz, Bunny Holland
BuNNy-RaBBiT Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

9/26/2023 7:14 AM	Rate (0)
AutoGen_1086188 Joined: 9/26/2023 Last visit: 9/26/2023 Posts: 1 Rating: (0)	Hello did you solve this problem. i have the same problem

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on