How to remove IO and format PLC ?

genious2015

 

Raijin

Hi

To continue diagnosing and be able to provide a solution, it would be very helpful if you upload the buffer in TXT format.

Best regards

 Thanks 

issue solved by remove IO and format PLC 

then download again 

[snip]

 Hi guys,

How to remove IO and format PLC ?
Is it meaning of PLC format factory reset ?

IO remove what?  Is it meaning to remove IO in HW config?   
My application porgram has the remote IO (ET200MP)

Please, inform me in detail.

------------------------------------------------------------------------------------------
Split from S7-1500 H switching problem.

Since you hijacked someone else's topic, let's first address what I *think* happened.

The topic starter was trying to configure a s7-1500 redundant PLC system but had a problem because they were using some I/O module(s) which were not compatible with use in a redundant system.  Once they removed the non-compatible hardware, reset PLC to factory defaults and loaded again using only compatible hardware, problem was solved.

I could be wrong.

However, all that said, perhaps you should create a new topic with your specific set of problems and what you need to resolve..  Thoughts?

Prosystech

genious2015

Raijin

Hi

To continue diagnosing and be able to provide a solution, it would be very helpful if you upload the buffer in TXT format.

Best regards

 Thanks 

issue solved by remove IO and format PLC 

then download again 

[snip]

 Hi guys,

How to remove IO and format PLC ?
Is it meaning of PLC format factory reset ?

IO remove what?  Is it meaning to remove IO in HW config?   
My application porgram has the remote IO (ET200MP)

Please, inform me in detail.