Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Micromaster 420 won't let me change parameter 10

Created by: Heksu at: 3/16/2024 8:13 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

3/16/2024 8:13 AM	Rate (0)
Heksu Bronze Member Joined: 12/12/2005 Last visit: 3/17/2024 Posts: 180 Rating: (12)	Micromaster 420 won't let me change parameter 10 (factory reset), what could be the reason? I have tried this on user level 3. The frequency converter was last used on the Profibus bus.
	Last edited by: Jen_Moderator at: 03/18/2024 12:13:11 Headline optimized. "Beer is proof that God loves us and wants us to be Happy"-Benjamin Franklin
Suggestion To thank Quote Answer

3/16/2024 11:59 AM	Rate (0)
Tractor Gold Member Joined: 3/27/2008 Last visit: 11/3/2024 Posts: 1144 Rating: (142)	What is r0002 showing? ensure there is no 'run' command selected. Is P0010 set to '0'? I am sure a 'Factory Reset', can be done at any time? ???? any one have an idea on this ??? Tractor
	Last edited by: Tractor at: 03/16/2024 12:01:40 Tractor
Suggestion To thank Quote Answer

3/16/2024 6:30 PM	Rate (0)
Graeme Platinum Expert Joined: 6/4/2008 Last visit: 10/10/2024 Posts: 1502 Rating: (325)	Hi, check that P927 = 0xF and then try changing P0010 again (technically if you are only using the BOP, then bit 2 (i.e. P927 = 0x2) is the only one required, but to be safe, we open up all 4 comms interfaces) You might need to RTFM if all you see is b---- on the BOP Regards, Graeme

Suggestion To thank Quote Answer

3/21/2024 7:25 PM	Rate (0)
pankaj_054 Experienced Member Joined: 3/13/2019 Last visit: 11/6/2024 Posts: 174 Rating: (2)	Dear Heksu, Try to change control card or and as per tractor sir suggetion see parameter r0002 . Regards, Pankaj

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on