Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

CP343-1 Lean V2.3 Hardware configuration

Created by: Digibit at: 10/25/2010 9:19 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

10/25/2010 9:19 AM	Rate (0)
Digibit Member Joined: 12/29/2008 Last visit: 10/16/2024 Posts: 5 Rating: (0)	The last delivery of CP343-1 Lean modules (6GK7343-1CX10-0XE0) contained firmware V2.3. Because this version was not yet available in my hardware catalog, I did an update of the latter. Although I found V2.3 in the update list, I can't find it in my hardware catalog after the update. I tried to update the catalog again, making sure I selected all available modules in the update, but same result. What is or can be the problem here?

Suggestion To thank Quote Answer

10/25/2010 10:39 AM	Rate (0)
Darius Platinum Member Joined: 9/28/2005 Last visit: 11/5/2024 Posts: 2957 Rating: (242)	Hello, I have Step-7 v5.5 and latest HW updates and I can see latest v2.2 firmware. I can't find v2.3 in HW catalog either. But I think this is not a problem. Just use v2.2 and forget .
	Best regards, Darius
Suggestion To thank Quote Answer

10/25/2010 7:13 PM	Rate (0)
UMENCHO Diamond Expert Joined: 3/21/2006 Last visit: 11/1/2024 Posts: 10229 Rating: (1181)	Hello, More info about the same issue on this thread CP343-1 Lean V2.3 not in Simatic HW Config list Best regards. Hristo Mihalev

Suggestion To thank Quote Answer

3/31/2011 7:22 PM	Rate (0)
PsyCrow Advanced Member Joined: 8/22/2009 Last visit: 6/8/2023 Posts: 26 Rating: (0)	Although you can configure with version 2.2 nobody has said where you can find the update to the catalog. There is a latest hardware catalog update, maybe help you. http://support.automation.siemens.com/WW/view/en/23183356
	Regards.
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on