Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

loadcell 2.5mV/V on Siwarex CS

Created by: marcop at: 5/4/2011 1:17 PM (4 Replies)

Rating (1)

Thanks 0

5 Entries

5/4/2011 1:17 PM	Rate (0)
marcop Experienced Member Joined: 12/3/2010 Last visit: 11/15/2024 Posts: 30 Rating: (0)	Hi, small question. Is it possible to us a loadcell with 2.5 mV/V characteristic valueon a siwarex CS module? because you can only choose between 1,2,4 mV/V in de Siwatool software. Thanks in advance, Marco.

Suggestion To thank Quote Answer

5/4/2011 2:26 PM	Rate (0)
Wishme Experienced Member Joined: 8/20/2009 Last visit: 11/6/2024 Posts: 80 Rating: (5)	Dear Marco, Yes u can use 3 mv/v load cell. What u have to do is to choose "Characteristic value" higher thanur load cell. -Vishal J. P.
	Vishme. Hang on...may be we drop a step before Success.
Suggestion To thank Quote Answer

5/5/2011 9:20 AM	Rate (0)
marcop Experienced Member Joined: 12/3/2010 Last visit: 11/15/2024 Posts: 30 Rating: (0)	Thanks for youre reply, Oke i will give it a try. Greetz.

Suggestion To thank Quote Answer

5/5/2011 5:19 PM	Rate (1)
Siwarexi Gold Expert Joined: 1/4/2007 Last visit: 11/13/2024 Posts: 1147 Rating: (175)	Hello marcop, If you have a loadcell wih 2.5 mV/V, you can set the characteristic value on the Siwarex CS module to 4 mV/V. Best regards Siwarexi

Suggestion To thank Quote Answer

5/10/2011 8:20 AM	Rate (0)
marcop Experienced Member Joined: 12/3/2010 Last visit: 11/15/2024 Posts: 30 Rating: (0)	Thanks for your'e advice guys....

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on