Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

what happens with T1 and T2

Created by: rdoliveira at: 5/16/2012 4:43 PM (2 Replies)

Rating (1)

Thanks 1

3 Entries

5/16/2012 4:43 PM	Rate (0)
rdoliveira Gold Member Joined: 4/26/2012 Last visit: 11/6/2024 Posts: 1560 Rating: (169)	I have a relay 3RK3 111-*AA10. What can happen if I put 24VDC from another source, in T1 and T2? Do you have any protection? T1 and T2 are modulated, which modulates the frequency is?
	"Always make a backup before and check the best time before testing." Obrigado.
Suggestion To thank Quote Answer

5/21/2012 11:59 AM	Rate (1)
LesPaul Posts: 467 Rating: (59)	hello, a 24VDC supply on T1/T2 can damage these test outputs The test signal depends on the set MSS cycle time. In addition to that, the signal changes for every cycle. Therefore, it's not possible to provide the frequency of the test signal. kind regards LesPaul
LesPaul Posts: 467 Rating: (59)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users rdoliveira

5/21/2012 12:39 PM	Rate (0)
rdoliveira Gold Member Joined: 4/26/2012 Last visit: 11/6/2024 Posts: 1560 Rating: (169)	OK, thanks for the information.
	"Always make a backup before and check the best time before testing." Obrigado.
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on