Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Pointer in S7 program

Created by: chintu at: 4/12/2007 3:27 PM (22 Replies)

Rating (3)

Thanks 0

Result pages:: |; 1 | 2 | 3; |

23 Entries

Entries per page: 10 | 20 | all

5/15/2007 5:13 PM	Rate (0)
Mi-k-l Posts: 41 Rating: (1)	Hi, I have a new problem! Always!! I am using the solution above. It works very well on PLCSIM but not on my PLC s7-400. The CPU diagnostic module show me I have an area lenght error in writing. Why? I wrote that: [code]LAR1 P##ptr_dest L B#16#10 T B [AR1,P#0.0] L B#16#2 //ID to implement Byte data type in ptr T B [AR1,P#1.0] L 2000 //Repetition factor T W [AR1,P#2.0] L 240 //DB-num T W [AR1,P#4.0] L "index_archive" //start address T D [AR1,P#6.0] [/code] index_archive increase the address of my pointer every 16000bytes. Where is mmy area lenght error? Greetings, Michael
Mi-k-l Posts: 41 Rating: (1)	Last edited by: Mi-k-l at: 15.05.2007 17:25 I forget, I use the function BLKMOV SFC20.
Suggestion To thank Quote Answer

5/17/2007 11:19 AM	Rate (0)
Thijs Posts: 121 Rating: (16)	What is the exact error message? How big is your DB240? Did you take in account that the "Index_archive" works in bit notation?
Thijs Posts: 121 Rating: (16)	Last edited by: Thijs at: 17.05.2007 11:20 Whoops, wrong button
Suggestion To thank Quote Answer

5/22/2007 4:40 PM	Rate (0)
Mi-k-l Posts: 41 Rating: (1)	Hi, It is ok, I found the solution. Thank you for your advice and your indication Greetings, Mi-k-l
Mi-k-l Posts: 41 Rating: (1)
Suggestion To thank Quote Answer

Result pages:: |; 1 | 2 | 3; |

23 Entries

Entries per page: 10 | 20 | all

|

Share this page:

Share this page on...

Follow us on