Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Wincc professional v11 - faceplate <> user data type issue

Created by: msozenautomation at: 1/19/2013 9:10 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

1/19/2013 9:10 PM	Rate (0)
msozenautomation Posts: 2 Rating: (0)	Hi everyone, I'm trying to make a faceplate in a wincc professional v11 project with a faceplate_property (interface) of a user defined type. There are only a handfull of system datatypes that can be selected for the properties. When i try to do this with wincc advanced v11 it does work and i can add my user defined type to the faceplate. /tf/WW/en/Posts/64058 I followed the instructions on this thread. It seems that wincc professional v11 does not support user data types in the faceplate interface?! Whats the difference on this between advanced and professional? I hope someone can help me on this.. With regards, Attachment Knipsel.jpg (613 Downloads)
msozenautomation Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

1/21/2013 1:10 PM	Rate (0)
Tweety Posts: 3037 Rating: (192)	msozenautomation It seems that wincc professional v11 does not support user data types in the faceplate interface?! Hello, Yes, this is correct. You can not use "user data types" in a faceplate of WinCC Professional V11. Tweety
Tweety Posts: 3037 Rating: (192)
Suggestion To thank Quote Answer

1/21/2013 1:55 PM	Rate (0)
msozenautomation Posts: 2 Rating: (0)	Thanks for the confirmation! So the work around that i can think of is using the same principle as in wincc V7? Define screens and using the tagprefix of those screens for a 'faceplate'-alike solution? Or are there other/better solutions to do this?
msozenautomation Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Installation Options General

Follow us on