Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Block list does not exist in PLC??Help

Created by: AUS_MB at: 9/15/2013 8:42 AM (4 Replies)

Rating (0)

Thanks 3

5 Entries

9/15/2013 8:42 AM	Rate (0)
AUS_MB Posts: 45 Rating: (0)	Hi All, When I try and download blocks from my Step 5 project to my S5-100U CPU102 I sometimes get the error 'Block list not in PLC'. What does this error mean? If I download a different project, without changing any CPU settings, the download works fine, so is it a problem with my program? Thanks Michael
AUS_MB Posts: 45 Rating: (0)
Suggestion To thank Quote Answer

9/16/2013 8:14 PM	Rate (0)
mjohan48 Member Joined: 11/28/2012 Last visit: 10/8/2024 Posts: 5 Rating: (0)	Hello!! What type of blocks are we talking about?

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users AUS_MB

9/16/2013 11:39 PM	Rate (0)
IBN-Service Posts: 8946 Rating: (999)	AUS_MB Hi All, When I try and download blocks from my Step 5 project to my S5-100U CPU102 I sometimes get the error 'Block list not in PLC'. What does this error mean? If I download a different project, without changing any CPU settings, the download works fine, so is it a problem with my program? Thanks Michael If you select "B" = transfer all blocks, but i.e. DB does not exist, you will get the message "'Block list not in PLC'" because there is no DB to transfer But if PLC ist working, that is not a problem, just an information.
IBN-Service Posts: 8946 Rating: (999)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users AUS_MB

9/17/2013 3:02 AM	Rate (0)
AUS_MB Posts: 45 Rating: (0)	Thanks for your replies I am trying to download the project blocks, that's all. Nothing special. I used the command 'A' in the block list to transfer all blocks, not 'B' I've attached a photo of the error that I am getting As far as I can see there's nothing wrong with my program, I might have to check again. Attachment S5error.jpg (287 Downloads)
AUS_MB Posts: 45 Rating: (0)	Last edited by: AUS_MB at: 9/17/2013 3:03 AM
Suggestion To thank Quote Answer

9/17/2013 3:32 AM	Rate (0)
AUS_MB Posts: 45 Rating: (0)	Hi All. I think I have figured it out. I was trying to download a program block PB100 which is outside the maximum allowed PBs (0 to 63 on this CPU) Attachment CPU102Spec.jpg (338 Downloads)
AUS_MB Posts: 45 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users O_Moderator

|

Share this page:

Share this page on...

Follow us on