Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

symbols and comments in microwin

Created by: tamer at: 11/20/2006 1:37 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

11/20/2006 1:37 PM	Rate (0)
tamer Posts: 5 Rating: (0)	Dear all siemens user, When I download the program with symbol table (symbols for inputs and outputs)and after that when I make upload the program from CPU the symbols not appear why?. And how can I download the program with symbols and comments it's important for commissioning and modification after time.[:cry:]
tamer Posts: 5 Rating: (0)
Suggestion To thank Quote Answer

11/20/2006 2:24 PM	Rate (0)
Essam Posts: 47 Rating: (0)	give the source program with samples to your client Best Regardes Essam Banat
Essam Posts: 47 Rating: (0)
Suggestion To thank Quote Answer

8/1/2007 9:11 AM	Rate (0)
henno2000 Posts: 177 Rating: (0)	Hi, Am I correct in assuming that the comments/sybol table cannot be retrieved from the PLC? (One of our program backups is corrupted, and I have obtained the program from the PLC, but there are no comments or symbols) Regards, henno2000
henno2000 Posts: 177 Rating: (0)
Suggestion To thank Quote Answer

8/1/2007 10:46 PM	Rate (0)
Manc Posts: 37 Rating: (2)	When the program is downloaded to the plc, the comments and symbolic addresses are not downloaded. So if you upload from a plc, you don't get these - all you get is the actual program with std addressing and no comments.
Manc Posts: 37 Rating: (2)
Suggestion To thank Quote Answer

8/2/2007 9:12 AM	Rate (0)
henno2000 Posts: 177 Rating: (0)	Many thanks for the information
henno2000 Posts: 177 Rating: (0)
Suggestion To thank Quote Answer

8/2/2007 5:07 PM	Rate (0)
Nestor Posts: 22 Rating: (1)	Hi, You can use the MC291 memory module to save the MicroWin project (including symbols and comments). Use S7-200 Explorer to save the project to the memory module Regards
Nestor Posts: 22 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on