Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

STARTER 4.0 and sinamics S 120

Created by: Miki Rapaic at: 8/26/2007 8:58 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

8/26/2007 8:58 PM	Rate (0)
Miki Rapaic Posts: 42 Rating: (0)	Hi there : I have a problem concerning sinamics S 120 and starter software.... I'm using starter software 4.0.. and with this i created my project... The problem is next: I'm trying to load this project to CU 320 using RS 232 port but I can't establish the communication ... I tried withRS 232cable, PG/PC settings (USS...) but i couldn't get it right.... My questions are next: Which cable should I use ...? What should I set for PG/PC (USS) ?? What transfer rate should i set (9600) ?? We wont to use PROFIBUS communication after we download project (is this a problem) ? Do I have to set anything else on S 120 or Starter 4.0 before going online ? Is there anything elese to do or set ??? I hope someone can help me with this, i really need this informations.... P.S Strange, we prepared entire project and we can't do anything beforewe fix this And our provider said we could download this just fine using RS 232 port and cable we used withG 110
Miki Rapaic Posts: 42 Rating: (0)
Suggestion To thank

8/27/2007 10:44 AM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 11/6/2024 Posts: 4109 Rating: (195)	closed cause question posted four times: The thread with all replays is posted with the subject Downloading from starter to SINAMICS S120 CU 320within the conference SINAMICS. Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on