Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

simodrive 611 communication problems

Created by: daniel2007 at: 8/31/2007 12:08 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

8/31/2007 12:08 PM	Rate (0)
daniel2007 Posts: 14 Rating: (0)	I have a communication problem with simodrive 611 digital. I tried with SimoComU and Rs232. With simodrive 611 universal works fine.Is there a diffrence between them? Thanks
daniel2007 Posts: 14 Rating: (0)
Suggestion To thank

8/31/2007 10:02 PM	Rate (0)
Dave Posts: 271 Rating: (29)	Hello Daniel2007, SimoCom U is designed to work with Simodrive 611U and POSMO CA/CD/SI products only. Simodrive 611D drives are designed for use with Sinumerik 840C, 840D and 810D CNC products only; therefore, the communication to the 611D is via SinuCom NC or via the HMI for the CNC. Hope this helps...
Dave Posts: 271 Rating: (29)
Suggestion To thank

9/1/2007 6:11 AM	Rate (0)
daniel2007 Posts: 14 Rating: (0)	Thanks Dave
daniel2007 Posts: 14 Rating: (0)
Suggestion To thank

9/1/2007 7:28 AM	Rate (0)
daniel2007 Posts: 14 Rating: (0)	SinuCom NC can be downloaded from a link on siemens suport or is available only by order?
daniel2007 Posts: 14 Rating: (0)
Suggestion To thank

9/4/2007 11:45 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 11/14/2024 Posts: 4113 Rating: (195)	closed cause the last question is published within a new thread too. The newer one which got a reply is published within the same conference with the subject SinuCom NC Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on