Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Wincc Flexible 2008 to TIA Portal V13

Created by: jack_lohana at: 8/11/2016 10:15 AM (3 Replies)

Rating (1)

Thanks 1

4 Entries

8/11/2016 10:15 AM	Rate (1)
jack_lohana Posts: 93 Rating: (2)	Hello Experts! I previously made a HMI on WinCC Flexible 2008 SP3. Now I need it to migrate to TIA Portal V13. I need your precious guidance for this task. Thanks Jack
jack_lohana Posts: 93 Rating: (2)
Suggestion To thank Quote Answer

8/11/2016 10:27 AM	Rate (0)
Ste39 Platinum Member Joined: 1/21/2013 Last visit: 10/23/2024 Posts: 4620 Rating: (708)	jack_lohana Hello Experts! I previously made a HMI on WinCC Flexible 2008 SP3. Now I need it to migrate to TIA Portal V13. I need your precious guidance for this task. Thanks Jack Hello, Have you already seen this: Migration Tool for TIA Portal - ID: 58638200 - Industry Support Siemens How do you migrate a project integrated in STEP 7 from WinCC ...
	Last edited by: Ste39 at: 8/11/2016 10:30:02 AM
Suggestion To thank Quote Answer

8/11/2016 10:27 AM	Rate (0)
ChristophD Grandmaster Joined: 5/12/2006 Last visit: 11/18/2024 Posts: 22453 Rating: (3030)	Hello, depends on which panel you have configured in WinccFlexible you need a WinCC Comfort/Advanced installation. Start TIA and in the portal view click on "Migrate Project" Navigate to the Folder with the WinCCFlex Project and select the .hmi File, click ok Activate the Checkbox "including HWConfig" if available Select the storage location of the migrated project. click on migrate to start the migration. Regards Christoph

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users ansans

8/16/2016 10:27 AM	Rate (0)
C.Change Bronze Member Joined: 11/15/2012 Last visit: 11/1/2024 Posts: 143 Rating: (10)	You may need a "save and optimize" job in wincc flexible file menu to make sure the immigration works. Good luck.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on