Navigation

MOTOR ROTATE SLOWLY WITHOUT SETPOINT AFTER ON COMMAND

Created by: AutoGen_333109 at: 4/17/2017 7:01 AM (1 Replies)

4/17/2017 7:01 AM	Rate (0)
AutoGen_333109 Experienced Member Joined: 12/30/2013 Last visit: 10/28/2024 Posts: 87 Rating: (0)	Dear sir, I am using 6RA80 dc drive(400 AMP.). with techo feedback. Perform the optimization runs successfully. But motor rotate slowly without setpoint after drive on command. Check the armature cable and techo cable are ok. and distance between each other is 2mters. With best regards, Binit kumar

Suggestion To thank Quote Answer

4/17/2017 9:25 AM	Rate (0)
mindware Platinum Member Joined: 3/30/2011 Last visit: 11/9/2024 Posts: 736 Rating: (258)	Hello, AutoGen_333109 .......But motor rotate slowly without setpoint after drive on command................. this is not enough clear, please explain better your situation.... You have to check reference (here the complete manual), what value do you read in r52170?? Attachment 6ra80_ref.JPG (179 Downloads)
	★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★ PS: If this post did really help you, you may use the Rate-button ★★★ ★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★★
Suggestion To thank Quote Answer