Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Can not connect to S7 200 series

Created by: Arturas.B at: 6/16/2008 2:56 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

6/16/2008 2:56 PM	Rate (0)
Arturas.B Posts: 6 Rating: (0)	Hello everyone, I am using IBM T60, CP5512 with HW adapter, V4.0 STEP 7 MicroWIN with SP3. In the PG/PC interface CP5512 (Auto) is selected. In the properties menu i try to detect network, but after some seconds error message appear "The bus parameters could not be determined because a communication error occoured. Check the installation of the interface and the cabling". This problem is with all S7-200 series that i have. There is nothing wrong with card or adapter as i have no connection problems with S7-300 and S7-400 series. Any ideas, what could be wrong? BR Arturas.
Arturas.B Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

6/16/2008 5:54 PM	Rate (0)
lc00 Posts: 1 Rating: (0)	set cp5512(PPI) in set PG/PC interface and test again
lc00 Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

6/17/2008 7:28 AM	Rate (0)
Arturas.B Posts: 6 Rating: (0)	Hello Ic00, I did what You said, but no luck, now i have error message "Communications time-out. Check the port number, network address, baud rate, and the attached cable.". BR Arturas.
Arturas.B Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

6/18/2008 10:48 AM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/12/2024 Posts: 8768 Rating: (1170)	Hello Arturas.B, I guess you have the following parameters: Address is 0, Transmission rate is 19.2 kbps and highest station address is 31. Have you selected the option 'Advanced PPI' ? Best regards, Wizard

Suggestion To thank Quote Answer

6/19/2008 7:43 AM	Rate (0)
Arturas.B Posts: 6 Rating: (0)	Hello Wizard, I have tried all possible ways, but no luck. After reinstall of MicroWin everything went ok. BR Arturas.
Arturas.B Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

6/19/2008 9:56 AM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/12/2024 Posts: 8768 Rating: (1170)	I'm glad everything is working now. Best regards, Wizard

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on