Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Can't transfer Software to my TP070 (SOLVED)

Created by: G-Hawk at: 10/13/2008 7:03 AM (3 Replies)

Rating (1)

Thanks 0

4 Entries

10/13/2008 7:03 AM	Rate (0)
G-Hawk Posts: 7 Rating: (0)	Hi... I'm using WinCC flexibe to programa a TP070, but I cannot be able to transfer the file. On transfer options I can't select the port to connect, I set the trasfer via serial @ 19.2 kbps but I can get any information of the port (get a blamk option). So when tthe trying to transfer I got a message that said unable to comunicate with equipment. Also WinCC don't have an option for TP070 panel, options start from TP170, I don't know if that could be a problem... Anyway I try to transfer from TP070, using the transfer option but it said that CAN'T CONNECT WITH DEVICE or something like that... Can anybody help me with that... Thanks!
G-Hawk Posts: 7 Rating: (0)	Last edited by: G-Hawk at: 10/16/2008 3:58 AM Set as resolved
Suggestion To thank Quote Answer

10/13/2008 8:55 AM	Rate (1)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 11/11/2024 Posts: 8768 Rating: (1170)	Dear G-Hawk, When you have TP070, you can't use WinCC flexible See this link: http://support.automation.siemens.com/WW/view/en/28735883 You need TP-designer. Best regards, Wizard

Suggestion To thank Quote Answer

10/13/2008 9:24 AM	Rate (0)
Ayman Elotaify Platinum Expert Joined: 5/28/2008 Last visit: 11/6/2024 Posts: 4516 Rating: (839)	Dear all, When programming TP070, use TP designer software and use a serial cable (9-pin, one-to-one) cable. Regards,
	Ayman Elotaify
Suggestion To thank Quote Answer

10/16/2008 3:58 AM	Rate (0)
G-Hawk Posts: 7 Rating: (0)	Thanks!... that information was ver helpfull... Regards!
G-Hawk Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on