Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

802D Faulty message

Created by: Rajni at: 12/26/2012 4:56 PM (6 Replies)

Rating (0)

Thanks 0

7 Entries

12/26/2012 4:56 PM	Rate (0)
Rajni Bronze Member Joined: 12/14/2012 Last visit: 4/6/2023 Posts: 70 Rating: (2)	Sir I have one 802D m/c last 4 days m/s power shutdown Today morning when m/c start we face some problem in booting. when we selct the option there we get only three option 1 NORMAL MODE 2 SOFTWARE UPDATE 3 PLC STOP.. But its not given load save data & load default data my collegue also select all three option bt its not ok now what we have to do for this? We also do one another thing we press 1. > key 2. F2 key of Horizental 3. F2 key of Vertical Then we get option default data Really??? then we press Y again we get same Error
	Last edited by: KumarP at: 12/26/2012 5:23 PM Rajni
Suggestion To thank Quote Answer

12/27/2012 8:04 AM	Rate (0)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 12/9/2023 Posts: 8071 Rating: (863)	hello, Have you earlier saved the data or carried out series start up data, internally. Please check the selection of portection key level set on system. Please see the attachement & follow the sequence. It may help you. Attachment Loading internally backed up data.pdf (51 Downloads)

Suggestion To thank Quote Answer

12/27/2012 10:14 AM	Rate (0)
Rajni Bronze Member Joined: 12/14/2012 Last visit: 4/6/2023 Posts: 70 Rating: (2)	Sir its ok but its not open a default screen also i get only a error on screen error
	Rajni
Suggestion To thank Quote Answer

12/28/2012 5:23 AM	Rate (0)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 12/9/2023 Posts: 8071 Rating: (863)	Can you attach screen photo shot here?

Suggestion To thank Quote Answer

12/30/2012 5:17 AM	Rate (0)
Rajni Bronze Member Joined: 12/14/2012 Last visit: 4/6/2023 Posts: 70 Rating: (2)	Sir Thanx for responce. Now its automatically get ok. Is it possible that m/c power cut is a reason for this problem bt how it get ok.Is there another problem?
	Rajni
Suggestion To thank Quote Answer

12/30/2012 11:55 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (476)	KumarP Sir Thanx for responce. Now its automatically get ok. Is it possible that m/c power cut is a reason for this problem bt how it get ok.Is there another problem? Hello, Please check your 24v dc supply which is given to this ? Ensure your 0V is properly grounded.. Ensure PCU is properly grounded. Just a suggestion... Regards, Prakash
Ekalavya Posts: 2964 Rating: (476)
Suggestion To thank Quote Answer

12/31/2012 9:47 AM	Rate (0)
Rajni Bronze Member Joined: 12/14/2012 Last visit: 4/6/2023 Posts: 70 Rating: (2)	Sir I check all this condition, Found ok. thanx for your support again.
	Last edited by: KumarP at: 1/2/2013 7:42 AM Rajni
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on