Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

802D rapid/feed rate display problem.

Created by: PISCEAN 2010 at: 6/1/2011 2:07 PM (6 Replies)

Rating (0)

Thanks 0

7 Entries

6/1/2011 2:07 PM	Rate (0)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 11/23/2024 Posts: 8092 Rating: (880)	Hello Experts, New lathe with 802D is installed in shop. In jog mode axes travel rate in mm/min, either in rapid or in feed is not displayed in main screen. If by operating vertical soft key feed axes is activated then only travel rate in mm/min is displayed. Which parameter needs to be set so that axes travel rate in mm/min shall be displayed in main screen? Thanks in advance.

Suggestion To thank Quote Answer

6/1/2011 2:32 PM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 1/22/2025 Posts: 595 Rating: (64)	Hi. May be: 20150[14]=2 - G94 - mm/min 20150[14]=3 - G95 - mm/rev Best regards.

Suggestion To thank Quote Answer

6/1/2011 2:37 PM	Rate (0)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 11/23/2024 Posts: 8092 Rating: (880)	I know these G codes. Problem is suppose if Z axis is moved in rapid at 2000 mm/min, then on main screen it should display the same. At present rapid 100% is displayed but it doesn’t display the figure 2000. Why?

Suggestion To thank Quote Answer

6/1/2011 2:49 PM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 1/22/2025 Posts: 595 Rating: (64)	You can show a screenshot.

Suggestion To thank Quote Answer

6/1/2011 4:15 PM	Rate (0)
OvidiuNastac Silver Member Joined: 1/29/2008 Last visit: 7/26/2022 Posts: 419 Rating: (19)	Hi I don't think that you can change the rapid display mode. This is the way in which is displayed the rapid feed rate as well as in other controllers. Good luck Nit

Suggestion To thank Quote Answer

6/2/2011 6:33 AM	Rate (0)
PISCEAN 2010 Diamond Expert Joined: 4/23/2010 Last visit: 11/23/2024 Posts: 8092 Rating: (880)	I will try & come back with screen shot

Suggestion To thank Quote Answer

6/2/2011 7:19 AM	Rate (0)
pfuser Silver Member Joined: 9/18/2006 Last visit: 1/22/2025 Posts: 595 Rating: (64)	Nit Hi I don't think that you can change the rapid display mode. This is the way in which is displayed the rapid feed rate as well as in other controllers. Good luck Nit I agree. This is the system software version of the lathe. You can try the milling version.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on