Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

810 ga3 load DM

Created by: CIRO1973 at: 11/6/2012 11:32 AM (5 Replies)

Rating (4)

Thanks 1

6 Entries

11/6/2012 11:32 AM	Rate (1)
CIRO1973 Bronze Member Joined: 10/14/2011 Last visit: 10/26/2022 Posts: 68 Rating: (57)	Hello I have to load the Dm on a lathe with 810 GA3. The owner has a floppy with these files PCA.NWD, PCP.NWD, SEA.NWD, SPF, TEA1.NWD and TEA2.NWD, 1.ERR, 2.ERR, 3.ERR, 4.ERR, 5.ERR, 6.ERR This extension NWD I never happened to find it I can upload them the same?

Suggestion To thank Quote Answer

11/6/2012 11:45 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (473)	Hello, Have you tried loading this...are you facing any error? Suggestion...could you please make copy of this before doing any thing... Open the copy which you have made...rename .NWD extension to .txt and loadit and check. Check it out... Regards, Prakash
Ekalavya Posts: 2964 Rating: (473)
Suggestion To thank Quote Answer

11/6/2012 4:26 PM	Rate (1)
CIRO1973 Bronze Member Joined: 10/14/2011 Last visit: 10/26/2022 Posts: 68 Rating: (57)	OK In a few days I'll go by the customer and I will try, I will let you know the outcome here on the forum Greetings

Suggestion To thank Quote Answer

11/14/2012 12:04 PM	Rate (2)
CIRO1973 Bronze Member Joined: 10/14/2011 Last visit: 10/26/2022 Posts: 68 Rating: (57)	Hi I changed the file extension, I managed to transfer only the PCP. During transmission the DIO appeared on CN but then when I try to move on he rest of the NC programs did not give no sign of communication while the pcin said the transferred file.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users thelittlemaintenance

5/29/2013 10:27 AM	Rate (0)
AutoGen_596172 Posts: 1 Rating: (0)	Also for us , is same problem, Please advice us any body,
AutoGen_596172 Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

5/29/2013 1:29 PM	Rate (0)
Ekalavya Posts: 2964 Rating: (473)	AutoGen_596172 Also for us , is same problem, Please advice us any body, Hello, With respect to your PM.....Yes you can give try.....RS232 Communications settings should be proper then it works... Your plc program should be PCP then it will get loaded..... Regards, Prakash
Ekalavya Posts: 2964 Rating: (473)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on