Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

810d 2002 setting drive data ffd no setting page for motor

Created by: SKIPPYSMT at: 6/7/2011 12:13 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

6/7/2011 12:13 PM	Rate (0)
SKIPPYSMT Member Joined: 12/17/2010 Last visit: 8/17/2020 Posts: 3 Rating: (0)	hello i,m a old xyz lathe from around 2002 the backup file is not upto date as some one has put a new motor on the turret 1fk7063-5af71-1eg3 and i cannt fine the motor setting page in this control as describe in later manual was this added later in the 810d range if so where do i find the setting for this motor to get the turret to run

Suggestion To thank

6/7/2011 12:39 PM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 11/23/2023 Posts: 2683 Rating: (135)	Thread closed, because question is already published in the following thread 810d 2002 setting drive data ffd no setting page for motor. Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on