Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

840D+ 1 Axis Power Module+2 Axis Control Card

Created by: chinna at: 4/29/2008 7:44 AM (2 Replies)

Rating (3)

Thanks 0

3 Entries

4/29/2008 7:44 AM	Rate (3)
chinna Experienced Member Joined: 9/10/2007 Last visit: 8/13/2024 Posts: 78 Rating: (3)	Dear sir, We are retrofitting the one CNC Machine which is having 6 axis and 1 Spindle. Those are X,Y,Z,SP,A,B. and C but X,Y,Z is having only one motor and 3 feedbacks. My problem is i am having single axis power module with dual axis control card. How to configure the second axis in the control card.After configuration of second axis NC displays the alarm as Power Module Inactive. Can anybody help me this.

Suggestion To thank Quote Answer

5/3/2008 7:45 AM	Rate (0)
Sanjoy 4m India Posts: 55 Rating: (2)	I have not checked with 840D system. But I found, we can use 2 axes power module + 1 axis control card not the reverse.
Sanjoy 4m India Posts: 55 Rating: (2)
Suggestion To thank Quote Answer

5/17/2008 9:21 PM	Rate (0)
Gebhardt Karl Platinum Expert Joined: 7/16/2006 Last visit: 1/2/2024 Posts: 1502 Rating: (176)	Hi >My problem is i am having single axis power module with dual axis control card. This is NO problem. Configuration is: Select if you have 1 - Axis modul. Push in with dual axis control card. You can tell me you Siemens-Numbers, then can i Check here.
	Karl
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on