Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

840d machine error

Created by: alexmac_uk at: 9/20/2012 10:29 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

9/20/2012 10:29 AM	Rate (0)
alexmac_uk Posts: 118 Rating: (1)	Hi, i am getting an error message "CHANNEL 1 AXIS X/X VDI-SIGNAL "DRIVE ENABLE" RESET DURING TRAVERSE MOTION" Any ideas what could cause this??
alexmac_uk Posts: 118 Rating: (1)
Suggestion To thank Quote Answer

9/20/2012 10:57 AM	Rate (0)
Nanu_333 Bronze Member Joined: 5/19/2011 Last visit: 12/23/2024 Posts: 196 Rating: (5)	Heloo which cnc controller you have? This problem is remoal of drive or axis ON command during traversal.check for any other error if present. Check inerlock in PLC for axis movement.Ther may be some interlock geting disturb while axis is in motion.

Suggestion To thank Quote Answer

9/20/2012 11:03 AM	Rate (0)
alexmac_uk Posts: 118 Rating: (1)	Hi, its sinumerik 840D controller. I will check for any other message
alexmac_uk Posts: 118 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on