Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

840D Questions

Created by: Jim Perry at: 3/15/2012 9:25 AM (5 Replies)

Rating (0)

Thanks 0

6 Entries

3/15/2012 9:25 AM	Rate (0)
Jim Perry Posts: 3 Rating: (0)	Hello all: I am working with an 840D control on a Spinner SB lathe. It was in storage for several years. It has an OP 031, MMC 100.2and 572.2 NCU. No PCU. I was getting the "waiting for communication" screen. Was able to start up by resetting the PLC. I am awaiting a new battery/fan module to arrive, then I will have to reload the parameters. What will be the procedue to reload the parameters? Do I need any special software to do it? The machine came with only 1 floppy disk. Would all the information be on one disk, or does it sound like I am missing disks? Thank you Jim P
Jim Perry Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

3/15/2012 10:09 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	Hello.... Check you should have your NC.archive and PLC archive backup with you.... Clear your NC and PLC on the NCU card i.e by the rotary switch /tf/WW/en/Posts/60254#top You can load your backups with RS232 with PCIN/WINPCIN software.... or with HMI advanced PC/PG that you need to install it on your PC/Laptop Regards, Prakash
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

3/15/2012 4:52 PM	Rate (0)
Jefke Advanced Member Joined: 9/15/2009 Last visit: 12/11/2024 Posts: 25 Rating: (0)	It is not the most safe sollution, but change the batterie when the control is switched on (and drives switched off - emergency stop) (Normally, when the machine is switched off, and you pull out the old batterie, you have 10 minutes to change batterie without data-loss) (if your machine is still OK, first make backup!)

Suggestion To thank Quote Answer

3/18/2012 1:14 AM	Rate (0)
Jim Perry Posts: 3 Rating: (0)	I replaced fan/battery module. I reset NCU and PLC. Control panel is in German now. Anyway to set to English?
Jim Perry Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

3/18/2012 10:14 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	Hello.... Can you able to find softkey IBN if you find it press it > in vertical keys you will find the softkey Change Language from there you can get it back to English Regards, Prakash
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

3/20/2012 7:41 AM	Rate (0)
Jim Perry Posts: 3 Rating: (0)	Thank you Prakash! I now have the screen in English. I have PCIN for my laptop. I'm getting a cable today. Jim
Jim Perry Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on