Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Active Line Module fault

Created by: Ziemens at: 2/10/2011 4:54 PM (3 Replies)

Rating (0)

Thanks 1

4 Entries

2/10/2011 4:54 PM	Rate (0)
Ziemens Silver Member Joined: 3/2/2007 Last visit: 1/9/2023 Posts: 818 Rating: (5)	Hy, has anyone seen the attached fault on an active line module? What does it mean? Thanks Attachment Alarm Window 1.GIF (268 Downloads)
	... thank you ...
Suggestion To thank Quote Answer

2/10/2011 5:31 PM	Rate (0)
DenisMor Posts: 344 Rating: (50)	The first time Active Line module powers up with default settings, it performs a line supply identification test as indicated by the 6,400 message. After frequency and voltage measurements are taken, the test completes and data is saved in the drive. If the measurement is not successful, 6,500 fault is displayed. Reasons can be a missing phase or low voltage on one of the phases. If the automatic line identification is turned off, it may be possible to operate the line module, but the right thing is to examine the quality of the incoming power supply.
DenisMor Posts: 344 Rating: (50)
Suggestion To thank Quote Answer

2/10/2011 5:33 PM	Rate (0)
Eyezerman Experienced Member Joined: 1/18/2008 Last visit: 1/13/2021 Posts: 10 Rating: (0)	I believe I've seen this fault about line synchronization a while ago when the wrong line frequency was selected (50 Hz instead of 60 Hz). However the input power frequencyis detected automatically in recent firmware versions, so I'm not sure what else can cause that error.

Suggestion To thank Quote Answer

2/11/2011 12:27 PM	Rate (0)
Ziemens Silver Member Joined: 3/2/2007 Last visit: 1/9/2023 Posts: 818 Rating: (5)	It turned out to be a loose connection on one of the phases ! Thanks all for your help .
	... thank you ...
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users O_Moderator

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on