Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Acyclic communication with S120 drives

Created by: DavidBrown at: 12/12/2016 8:36 PM (4 Replies)

Rating (0)

Thanks 1

5 Entries

12/12/2016 8:36 PM	Rate (0)
DavidBrown Gold Member Joined: 6/29/2012 Last visit: 2/1/2023 Posts: 962 Rating: (7)	I want to do acyclic communication with S120 drives from a S7 plc. The S120 system consists of CU320-2 PN and three double motor modules (6 motors). Can I read and write to all drives at the same time (same plc cycle), or only with one at a time, or is there a limitation ?

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users matix1

12/13/2016 8:16 AM	Rate (0)
jacek d Platinum Member Joined: 9/23/2005 Last visit: 2/6/2023 Posts: 4090 Rating: (630)	I'm not sure about this case. But in case of Simotion D and DPV1 services you can send only one request at a time per CU. AFAIK this is the CU resources limitation, so in your case it should be similar.
	Regards, Jacek What is confusing you is the fact that you never see a number but always its digit representation. So you end up thinking that the number is the representation. - Andrej Bauer Any claims against me - based on whatever legal reason - resulting from the use of any code and/or ideas presented on this forum shall be excluded. #StayWithUkraine
Suggestion To thank Quote Answer

12/13/2016 8:33 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 2/8/2023 Posts: 21237 Rating: (2800)	Hello, s7 have the same restrictions like Simotion D, only one request can be active. Regards Christoph

Suggestion To thank Quote Answer

12/23/2016 9:50 PM	Rate (0)
DavidBrown Gold Member Joined: 6/29/2012 Last visit: 2/1/2023 Posts: 962 Rating: (7)	ChristophD Hello, s7 have the same restrictions like Simotion D, only one request can be active. Regards Christoph To make it complete clear : If the situation is : S7 PLC, three CU320-2 PN each with 6 axes. Can I read in one plc-cycle a parameter from a drive of the first and the second and the third CU320-2PN? Or can I only read/write a parameter from one drive at a time even if the drives are connected to different CU's? Does it make a difference if the plc is a S7 300 or S7 1500,

Suggestion To thank Quote Answer

12/27/2016 8:10 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 2/8/2023 Posts: 21237 Rating: (2800)	Hello, you can read in one cycle parameters from the 3 Contrl units. No difference between S7-300 /S7-1500. Regards Christoph

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on