SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Adding a CP343-1

9/11/2014 9:36 PM	Rate (0)
WStripling Posts: 2 Rating: (0)	Guys, I have an existing project that's using a CPU315-2DP. I would like to add a CP343-1 to the project so so that I can access the processor from the plant ethernet network. I know how to add the processor to the hardware configuration. After that, I'm lost. Can anyone point me in the right direction on how to do this? Thanks, Nick
WStripling Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

9/11/2014 10:32 PM	Rate (0)
VVago Posts: 784 Rating: (52)	Hello, Kindly find attached file. Best regards..... Attachment HW_Config.JPG (58 Downloads)
VVago Posts: 784 Rating: (52)
Suggestion To thank Quote Answer

9/11/2014 10:42 PM	Rate (0)
WStripling Posts: 2 Rating: (0)	Wago, Thanks for the reply. I have added the CP to my hardware configuration and have assigned it an IP address. My question is do I need to do any programming to get the CP to go into Run mode and to be able to access it from the plant ethernet network? Thanks, Nick
WStripling Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

9/11/2014 10:46 PM	Rate (0)
VVago Posts: 784 Rating: (52)	Hello, MPI address,IP address and subnet address Perhaps this link might help. Best regards......
VVago Posts: 784 Rating: (52)	Last edited by: Wago at: 9/11/2014 10:49 PM
Suggestion To thank Quote Answer

9/12/2014 8:22 AM	Rate (0)
Pittiplatsch Posts: 1368 Rating: (128)	Hi, if you only want the CP for connection to Ethernet network, the CP needs an IP and subnet in the range of you other network components. That's all. A little bit more effort is it, if you use the CP as PROFINET Controller...(additional blocs etc.)
Pittiplatsch Posts: 1368 Rating: (128)
Suggestion To thank Quote Answer

Share this page:

Share this page on...