Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Addressing the IO modules

Created by: tamibandy at: 7/21/2015 9:07 AM (2 Replies)

Rating (2)

Thanks 3

3 Entries

7/21/2015 9:07 AM	Rate (0)
tamibandy Regular Member Joined: 5/11/2015 Last visit: 5/25/2023 Posts: 13 Rating: (0)	I want to add 2 DI modules(6ES7 131-4BD01-0AA0) for an ET200S with address I1.0 ... I1.3 for the first module and I1.4 ... I1.7 for the second module. After drag and drop the module, automatically gives I1.0 ... I1.3 address for the first module and I2.0 ... I2.3 address for the second module and it can't be modified the bit part of the address. How can change the address? Attachment siemens_addressing_issue.png (126 Downloads)
	Last edited by: tamibandy at: 7/21/2015 9:16:59 AM
Suggestion To thank Quote Answer

7/21/2015 9:50 AM	Rate (2)
mopS04 Platinum Expert Joined: 3/5/2014 Last visit: 8/5/2022 Posts: 5521 Rating: (1031)	hi, just adress the first, then you could select both modules and press a button in HW-Config to pack the adresses. See picture below regards Attachment packingadresses.png (90 Downloads)
	FCK WAR! Be nice!
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users tamibandy hdhosseini

7/21/2015 10:32 AM	Rate (0)
tamibandy Regular Member Joined: 5/11/2015 Last visit: 5/25/2023 Posts: 13 Rating: (0)	Thanks mopS04 This was what I have been searched :D

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Min_Moderator

|

Share this page:

Share this page on...

Follow us on