Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Adressing on 95U

Created by: vazcosta at: 10/17/2006 1:03 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

10/17/2006 1:03 PM	Rate (0)
vazcosta Posts: 2 Rating: (0)	Hi, In a configuration with a cpu 95U and I/O cards with 16 channels on slot's;0,1,2,3 and four. What is the adress of a card with 8 channels mounted on the slot 5??? I just try adress 0 and 5 but did not work!!! Thank you. Best regards. PC
vazcosta Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

10/17/2006 1:36 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 10/10/2024 Posts: 8745 Rating: (1168)	Hello, Here is a manual: http://support.automation.siemens.com/WW/view/en/1091648 Look at chapter 6. I would say it should be 5.0 etc. But perhaps you can try 104.0 Best regards, Wizard

Suggestion To thank Quote Answer

10/17/2006 2:37 PM	Rate (0)
PRK Posts: 38 Rating: (2)	Hi Address would be as below Slot 0 = 64.0 to 65.7 Slot 1 = 72.0 to 73.7 Slot 2 = 80.0 to 81.7 Slot 3 = 88.0 to 89.7 Slot 4 = 96.0 to 97.7 Slot 5 = 5.0 to 5.7 Regards, PRK
PRK Posts: 38 Rating: (2)
Suggestion To thank Quote Answer

10/17/2006 4:47 PM	Rate (0)
vazcosta Posts: 2 Rating: (0)	Hi, i just try 5 but did not work....i gone try again. Thank you. Best regards. PC
vazcosta Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

10/18/2006 9:06 AM	Rate (0)
Smurf Silver Member Joined: 9/28/2005 Last visit: 12/14/2022 Posts: 414 Rating: (28)	Hi vazcosta, Have you connected al the wireing at the right places? Is this 8 channel block an digital input or output? What happens if you place that 8 channel group in slot 0? what habbens if you switch some of the busmodules? As mentioned by the people before, the 16 channel IO blocks use the analog adresses, the IO-blocks upto 8 channels use the normal digital adresses (byte number is slot number).
	Smurf "The only difference between a problem and a solution is that people understand the solution."
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on