Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

AI Card (SF)

Created by: Palestine at: 11/16/2009 9:27 AM (5 Replies)

Rating (1)

Thanks 0

6 Entries

11/16/2009 9:27 AM	Rate (0)
Palestine Posts: 74 Rating: (0)	Hello all I have an AI Card6ES7331-7KF02-0AB0 when i use it to measure a voltage signal (E +/-10V) it works good. But when i change the configuration tomeasurea 4 - 20 mA and when i download the hardware configuration to the PLC the SF led For the card starts blinking check the following picture please. do i have to do something else. Best regards Attachment AI.JPG (175 Downloads)
Palestine Posts: 74 Rating: (0)
Suggestion To thank Quote Answer

11/16/2009 9:45 AM	Rate (0)
how come Posts: 382 Rating: (47)	Hi, Did you change theswitchof the AI card to position "D" with regards, how come
how come Posts: 382 Rating: (47)	Last edited by: how come at: 11/16/2009 9:46 AM
Suggestion To thank Quote Answer

11/16/2009 12:02 PM	Rate (0)
Palestine Posts: 74 Rating: (0)	Hello Now i did it, thank you. The SF is gone now but i don't have any reading form the AI, i havedeactivatedall the AI except the first one. Is there any thing else i have to do. Best regards Attachment AI.JPG (224 Downloads)
Palestine Posts: 74 Rating: (0)
Suggestion To thank Quote Answer

11/16/2009 1:28 PM	Rate (1)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 9/16/2024 Posts: 8737 Rating: (1168)	Hi, Are you using a passive or active sensor? 2DMU, means you have a passive sensor, the card is providing the necessary power. 4DMU, means you have an active sensor, supplied with power from outside. (measuring range module must be in position C) Best regards, Wizard

Suggestion To thank Quote Answer

11/17/2009 2:09 AM	Rate (0)
fritz Diamond Expert Joined: 10/7/2005 Last visit: 9/16/2024 Posts: 3020 Rating: (1054)	Hello Palestine and just in case Wizard's advise does NOT help, please try a different channel pair and/or card (you may have "smoked" thefirst channel pair by trying to feed mA's into a range module that was set for Volts). I hope this helps
	Cheers fritz The advice and opinion given in this thread is that of the author and does not necessarily reflect the views of I S Systems Pty Limited. To find out how I S Systems can help you with your automation needs please visit www.issystems.com.au.
Suggestion To thank Quote Answer

11/17/2009 4:44 AM	Rate (0)
how come Posts: 382 Rating: (47)	Hi, Apart from Wizard and fritz valuable advises, since you configured as 2DMU, what you can do to confirm the channel is ok is to use the meter to measure thechannel of the AI card. Put your meter to DC measurement. You should get some DC volts [approximate 22 to 24vdc] from the channel. If not then maybe the channel already faulty. Try the next channel. with regards, how come
how come Posts: 382 Rating: (47)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on