Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Alarm 20056 in Jog mode

Created by: M_A_S001 at: 4/23/2012 9:57 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/23/2012 9:57 PM	Rate (0)
M_A_S001 Posts: 6 Rating: (0)	Hi!. I have a 840Dsl and i have a problen. When i try move a axis (i have 2 axiss)in Jog modethe alarm 20056 "no revolutional feedrate possible. Axis/spindle X/X1 stationary" appears. If somebody had a idea, I´ll be so happy!. Thanks!
M_A_S001 Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

4/24/2012 5:51 AM	Rate (0)
Ekalavya Posts: 2964 Rating: (484)	Hello.... For the alarm 20056: An axis is to travel in JOG with revolutional feed, but the spindle/axis the feed is to be derived from is 0. Could you Traverse the spindle/axis from which the feed is to be derived. Regards, Prakash
Ekalavya Posts: 2964 Rating: (484)
Suggestion To thank Quote Answer

4/24/2012 5:54 AM	Rate (0)
RAM81 Silver Member Joined: 3/3/2008 Last visit: 10/5/2023 Posts: 333 Rating: (52)	hi try to find out whether G94 or G95 is active?/ command G94 in mda mode and jog the axes and check regards ram

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on